Configuring Rspan - Huawei Quidway S5600 Series Operation Manual

Operation Manual – Mirroring
Quidway S5600 Series Ethernet Switches-Release 1510
[Quidway] mirroring-group 1 local
[Quidway] mirroring-group 1 monitor-port GigabitEthernet 1/0/4
[Quidway] mirroring-group 1 mirroring-port GigabitEthernet 1/0/1 both

1.3.3 Configuring RSPAN

I. Configuration prerequisites
The source switch, intermediate switch, and the destination switch have been
determined.
The source port, the reflector port, the destination port, and the remote-probe
VLAN have been determined.
Required configurations are performed to ensure Layer 2
source and destination switches over the
The direction of the packets to be monitored has been determined.
The remote-probe VLAN is enabled.
II. Configuring RSPAN on the source switch
Table 1-8 Configure RSPAN on the source switch
Operation
Enter system view
Create a VLAN and
enter its VLAN view
Define
VLAN
remote-probe VLAN
Exit current view
Enter the view of the
ports that connected to
the intermediate switch
or destination switch
Configure the current
port as Trunk
Configure Trunk port to
permit packets from
the
VLAN
Exit current view
system-view
vlan vlan-id
the current
remote-probe
as a
enable
quit
interface
interface-type
interface-number
port link-type trunk
port trunk permit vlan
remote-probe remote-probe-vlan-id
quit
Huawei Technologies Proprietary
Chapter 1 Mirroring Configuration
remote-probe VLAN.
Command
—
vlan-id
destination
VLAN.
vlan
Required
—
—
Required
By default, the port type is
Access.
Required
This setting is required for
source
connected
intermediate
destination switch.
—
1-9
connectivity between the
Description
is the ID of the
remote-probe
switch ports that
with the
switch or