Huawei Quidway S5600 Series Operation Manual page 432

Operation Manual – Multicast Protocol
Quidway S5600 Series Ethernet Switches-Release 1510
II. Network diagram
Router
Switch
Figure 2-3 Network diagram for IGMP Snooping configuration
III. Configuration procedure
# Enable IGMP Snooping in system view.
<Quidway> system-view
[Quidway] igmp-snooping enable
# Enable IGMP Snooping on VLAN 10 where no Layer 3 multicast protocol is enabled.
[Quidway] vlan 10
[Quidway-vlan10] igmp-snooping enable
2.4.2 Example 2
Configure multicast VLAN on Layer 2 and Layer 3 switches.
I. Network requirements
The multicast source is Workstation. Switch A forwards the multicast data flows that the
multicast source sends. The multicast data flows are forwarded by the Layer 2 switch
Switch B to the end user PC1 and PC2.
Table 2-13 describes the network devices involved in this example and the
configurations you should make on them.
Table 2-14 Network devices and their configurations
Switch A
Internet
Multicast
Device
The interface IP address of VLAN 20 is 168.10.1.1.
The GigabitEthernet1/0/1 port is connected to the
Layer 3 switch
workstation and belongs to VLAN 20.
VLAN 10 is the multicast VLAN.
Huawei Technologies Proprietary
Chapter 2 IGMP Snooping Configuration
Description
2-14