Configuring Rate Limit On Ports - Huawei Quidway S5600 Series Operation Manual

Operation Manual - QoS&QoS Profile
Quidway S5600 Series Ethernet Switches
Operation
Set
precedence of the
protocol packet
Display
precedence of the
protocol packet
1.6.3 Configuration Example
Set the IP precedence of the ICMP protocol packet to 3.
Display the configuration results.
Configuration procedure:
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] protocol-priority protocol-type icmp ip-precedence 3
[Quidway] display protocol-priority
Protocol: icmp
IP-Precedence: flash(3)

1.7 Configuring Rate Limit on Ports

1.7.1 Configuration Prerequisites
The ports where rate limit is to be performed is specified
The target rate is specified
The direction of rate limit is specified
1.7.2 Configuration Procedure
Table 1-11 Configure rate limit on ports
Operation
Enter
view
Enter
port view
Command
protocol-priority
protocol-type
the
protocol-type
{ ip-precedence
ip-precedence
dscp-value }
the
display
protocol-priority
Command
system
system-view
Ethernet interface interface-type
interface-number
Huawei Technologies Proprietary
Required
You can modify the IP precedence
or DSCP precedence of
protocol packet
Only the precedence of BGP,
| dscp
TELNET, OSPF, SNMP, and ICMP
protocol packets
currently
Optional
You can execute the display
command in any view
—
—
1-16
Chapter 1 QoS Configuration
Description
is supported
Description
the