Huawei Quidway S5600 Series Operation Manual page 336

Operation Manual – Routing Protocol
Quidway S5600 Series Ethernet Switches-Release 1510
Note:
On the same interface, you can disable multiple OSPF processes from transmitting
OSPF packets. The silent-interface command, however, only applies to the OSPF
interface where the specified process has been enabled, without affecting the
interface for any other process.
After an OSPF interface is set to be in silent status, the interface can still advertise
its direct route. However, the Hello packets from the interface will be blocked, and no
neighboring relationship can be established on the interface. This enhances OSPF
networking adaptability, thus reducing the consumption of system resources.
4.7.6 Configuring OSPF Authentication
Table 4-18 Configure OSPF authentication
Enter system view
Enter OSPF view
Enter OSPF area view
Configure
mode of the OSPF area
Return to OSPF view
Return to system view
Enter interface view
Configure
mode of the OSPF interface
Operation
the authentication
the authentication
Huawei Technologies Proprietary
Command
system-view
ospf [ process-id
[ router-id router-id ] ]
area area-id
authentication-mode
{ simple | md5 }
quit
quit
interface
interface-type
interface-number
ospf
authentication-mode
{ simple password |
md5 key-id key }
4-23
Chapter 4 OSPF Configuration
Description
—
—
—
Required
By default,
authentication mode is
configured for an area.
—
—
—
Required
By default, OSPF
packets are
authenticated on an
interface.
no
not