Huawei Quidway S5600 Series Operation Manual page 471

Operation Manual – Multicast Protocol
Quidway S5600 Series Ethernet Switches-Release 1510
7.2.4 Clearing the Related PIM Entries
You can execute the reset command in user view to clear the related statistics about
multicast PIM.
Table 7-5 Clear the related PIM entries
Operation
Clear
entries
Clear PIM neighbors
7.3 PIM-DM Configuration
Perform the following configuration to configure PIM-DM. When the router runs in
PIM-DM domain, you are recommended to enable PIM-DM on all the interfaces of
non-boarder routers.
7.3.1 Configuring Filtering Policies for Multicast Source/Group
Table 7-6 Configure filtering policies for multicast source/group
Operation
Enter system view
Enable
routing protocol
Enter PIM view
Perform
filter on
multicast packets
reset pim routing-table
{ all | { group-address
[ mask group-mask |
mask-length
group-mask-length
source-address [ mask
the PIM route
source-mask
mask-length
source-mask-length
{
{
interface-number
null } } } * }
reset pim neighbor { all |
{
interface
interface-number } * }
system-view
the multicast multicast
routing-enable
pim
source/group
source-policy
the received
acl-number
Huawei Technologies Proprietary
Command
] |
|
] |
incoming-interface
interface-type
|
neighbor-address |
interface-type
Command
7-13
Chapter 7 PIM Configuration
Description
Perform the configuration
in user view.
Perform the configuration
in user view.
Description
—
Required
—
Optional
You can configure to filter
the IP addresses of some
multicast groups in ACL.