Huawei Quidway S5600 Series Operation Manual page 730

Operation Manual - QoS&QoS Profile
Quidway S5600 Series Ethernet Switches
Operation
Configure
traffic-based TP
Display the parameter
configurations
traffic policing
Display all the QoS
settings of the port
acl-rule: Applied ACL rules which can be the combination of various ACL rules. The
way of combination is described in Table 1-9.
Note:
The granularity of TP is 64 kbps. If the number you input is in the range of N*64 to
(N+1)*64 (N is a natural number), the switch will set the value to (N+1)*64 kbps
automatically
TP configuration is effective only for the ACL rules whose actions are permit.
1.8.3 Configuration Example
GigabitEthernet1/0/1 of the switch is accessed to the 10.1.1.1/24 network
segment
Perform TP on the packets from the 10.1.1.1/24 network segment and the rate of
TP is set to100 kbps
The packets beyond the specified traffic are forwarded after their DSCP
precedence is marked as 56
Configuration procedure:
Command
traffic-limit inbound
acl-rule target-rate
[ exceed action ]
display
qos-interface
of { interface-type
interface-number
unit-id } traffic-limit
display
qos-interface
{ interface-type
interface-number
unit-id } all
Huawei Technologies Proprietary
1-18
Chapter 1 QoS Configuration
Description
Required
exceed exceed-action: Sets the
actions on the packets exceeding
the specified traffic when the
packet traffic exceeds
specified traffic. The actions
include:
drop: Drops the packets.
remark-dscp
Resets the DSCP precedence
of the packets and forwards
them at the same time.
|
Optional
You can execute the display
command in any view
|
the
dscp-value: