Defining Layer 2 Acls - Huawei Quidway S5600 Series Operation Manual

Operation Manual – ACL
Quidway S5600 Series Ethernet Switches-Release 1510
reassembly-timeout
source-quench
source-route-failed
timestamp-reply
timestamp-request
ttl-exceeded
1.4.3 Configuration Example
# Configure ACL 3000 to permit ICMP packets to pass.
<Quidway> system-view
[Quidway] acl number 3000
[Quidway-acl-adv-3000] rule 0 permit icmp
[Quidway-acl-adv-3000] display acl 3000
Advanced ACL
Acl's step is 1
rule 0 permit icmp

1.5 Defining Layer 2 ACLs

Layer 2 ACLs define rules based on the Layer 2 information such as the source and
destination MAC address information, VLAN priority and Layer 2 protocol to process
packets.
The value range for Layer 2 ACL numbers is 4,000 to 4,999.
1.5.1 Configuration Preparation
Before configuring an ACL rule containing time range arguments, you need to configure
define the corresponding time ranges. For the configuration of time ranges, refer to
section 1.2 "Configuring Time Ranges".
The values of the source and destination MAC addresses, VLAN priority and Layer 2
protocol in the rule have been defined.
1.5.2 Configuration Tasks
Table 1-11 Create a Layer 2 ACL rule
Operation
Enter system view
Name
Type=11
Type=4
Type=3
Type=14
Type=13
Type=11
3000, 1 rule
Command
system-view
Huawei Technologies Proprietary
ICMP TYPE
—
1-12
Chapter 1 ACL Configuration
ICMP CODE
Code=1
Code=0
Code=5
Code=0
Code=0
Code=0
Description