Huawei Quidway S5600 Series Operation Manual page 454

Operation Manual – Multicast Protocol
Quidway S5600 Series Ethernet Switches-Release 1510
II. Limit the range of multicast groups that the interface serves
The Layer 3 switch determines the membership of the network segment through
translating the received IGMP join packets. You can configure a filter for each interface
to limit the range of multicast groups that the interface serves.
Table 6-4 Configure IGMP multicast groups on the interface
Operation
Enter system view
Enter
view
Enable
current interface
Configure limit on the
number of joined IGMP
groups on the interface
Limit
multicast groups that the
interface serves
Quit interface view.
Enter Ethernet port view
system-view
VLAN interface interface Vlan-interface
interface-number
IGMP on the
igmp enable
igmp group-limit limit
igmp
acl-number [ 1 | 2 | port
the range of
interface-type
interface-number
interface-type
interface-number ] ]
quit
interface
interface-number
Huawei Technologies Proprietary
Command
group-policy
[ to
interface-type
6-10
Chapter 6 IGMP Configuration
Description
—
—
Required
IGMP is disabled on the
interface by default.
Required
By default, the number of
multicast groups passing
a port is not limited.
Optional
By default, the filter is
not configured, that is,
any multicast group is
permitted on a port.
If the port keyword is
specified, the specified
port must belong to the
VLAN of the VLAN
interface.
You can configure to
filter the IP addresses
of some multicast
groups in ACL.
1 and 2 are the IGMP
version numbers.
IGMPv2 is used by
default.
-
-