Setting To Use The Port Priority Or Packet Priority - Huawei Quidway S5600 Series Operation Manual

Operation Manual - QoS&QoS Profile
Quidway S5600 Series Ethernet Switches
Display the mapping table
III. Configuration example
Configure the following 802.1p priority-to-local precedence mappings: 0 to 2, 1 to
3, 2 to 4, 3 to 1, 4 to 7, 5 to 0, 6 to 5, and 7 to 6.
Display the configuration results.
Configuration procedure:
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] qos cos-local-precedence-map 2 3 4 1 7 0 5 6
[Quidway] dis qos cos-local-precedence-map
cos-local-precedence-map:
--------------------------------------------------------------------------
local precedence(queue) :

1.4 Setting to Use the Port Priority or Packet Priority

By default, the switch replaces the 802.1p priority of the received packet with the
priority of the inbound interface, and then assigns local precedence for the packet
according to the priority. In this case, you can set the port priority.
In addition, you can specify the switch to use the packet priority.
I. Configuration prerequisites
The priority trust mode is specified
The port whose priority is to be configured is specified
The priority value of the specified port is specified
II. Configuration procedure
Table 1-6 Set to use the port priority
Operation
Enter system view
Enter Ethernet port
view
Operation
display
cos-local-precedence-map
cos(802.1p) :
system-view
interface
interface-number
Huawei Technologies Proprietary
Command
0 1 2
2 3 4
Command
—
interface-type
—
1-12
Chapter 1 QoS Configuration
Description
Optional
qos
You can execute the
display command in
any view
3 4 5
1 7 0
Description
6 7
5 6