Ethernet Port Configuration; Initially Configuring A Port - Huawei Quidway S5600 Series Operation Manual

Operation Manual – Port Basic Configuration
Quidway S5600 Series Ethernet Switches-Release 1510
An access port can only be added to one VLAN, while hybrid and trunk ports can be
added to multiple VLANs.
Note:
The access ports or hybrid ports must be added to an existing VLAN.

1.2 Ethernet Port Configuration

1.2.1 Initially Configuring a Port

Table 1-4 Initially configure a port
Operation
Enter system view
Enter
view
Enable
port
Set the description of
the Ethernet port
Set the duplex mode of
the Ethernet port
Set the speed of the
Ethernet port
Set
dependent
(MDI) attribute of the
Ethernet port
Allow
that are not larger than
9216 bytes to pass
through the Ethernet
port
system-view
Ethernet port interface interface-type
interface-number
the Ethernet
undo shutdown
description text
duplex { auto | full |
half }
speed { speed-value |
auto }
the medium
interface mdi { across | auto |
normal }
jumbo frames
jumboframe enable
Huawei Technologies Proprietary
Chapter 1 Port Basic Configuration
Command
—
—
Optional
By
enabled.
Use
command to disable the port.
Optional
By default, no description is
defined for the port.
Optional
By default, the duplex mode
of
(auto-negotiation).
Optional
By default, the speed of the
port
(auto-negotiation).
Optional
Be default, the MDI attribute
of the port is auto.
Optional
By default, jumbo frames that
are not larger than 9216
bytes are allowed to pass
through the port.
1-4
Remarks
default, the port
the shutdown
the port is auto
is auto
is