Configuring The Cost For Sending Packets On An Ospf Interface; Setting Ospf Route Priority - Huawei Quidway S5600 Series Operation Manual

Operation Manual – Routing Protocol
Quidway S5600 Series Ethernet Switches-Release 1510
Note:
OSPF is a dynamic routing protocol based on link state, with routing information hidden
in LSAs. Therefore, OSPF cannot filter any advertised or received LSA. In fact, the
filter-policy import command filters the routes calculated by OSPF; only the routes
passing the filter can be added to the routing table.

4.6.4 Configuring the Cost for Sending Packets on an OSPF Interface

Table 4-10 Configure the cost for sending packets on an OSPF interface
Enter system view
Enter interface view
Configure the cost for sending
packets on an OSPF interface

4.6.5 Setting OSPF Route Priority

Since multiple dynamic routing protocols may be running on one router, the problem of
route sharing and selection between various routing protocols arises. The system sets
a priority for each routing protocol (which you can change manually), and when more
than one route to the same destination is discovered by different protocols, the route
with the highest priority will take preference over other routes.
Table 4-11 Set OSPF route priority
Enter system view
Enter OSPF view
Operation
Operation
system-view
ospf
[ router-id router-id ] ]
Huawei Technologies Proprietary
Command
system-view
interface
interface-type
interface-number
ospf cost value
Command
[ process-id
4-17
Chapter 4 OSPF Configuration
Description
—
—
Optional
By default, OSPF
calculates the cost for
sending packets on an
interface according to
the current baud rate
on the interface. For a
VLAN interface on the
switch, this value is
fixed at 10.
Description
—
—