Huawei Quidway S5600 Series Operation Manual page 378

Operation Manual – Routing Protocol
Quidway S5600 Series Ethernet Switches-Release 1510
Create
an
EBGP
peer
group
Create
a hybrid
EBGP
peer
group
Finish the session with the
specified peer/peer group
Caution:
It is not required to specify an AS number for creating an IBGP peer group.
If there already exists a peer in a peer group, you can neither change the AS
number of the peer group, nor delete a specified AS number through the undo
command.
In a hybrid EBGP peer group, you need to specify the AS number for all peers
respectively.
5.7.3 Configuring BGP Community
Table 5-16 Configure BGP community
Enter system view
Enable BGP, and enter BGP
view
Operation
Create an EBGP
peer group
Configure the AS
number of a peer
group
Add a peer to a
peer group
Create an EBGP
peer group
Add a peer to a
peer group
Operation
Huawei Technologies Proprietary
Command
group group-name
external
peer group-name
as-number
as-number
peer ip-address
group group-name
[ as-number
as-number ]
group group-name
external
peer ip-address
group group-name
[ as-number
as-number ]
peer { group-name |
ip-address }
shutdown
Command
system-view
bgp as-number
5-33
Chapter 5 BGP Configuration
Description
Optional
You can add multiple peers
to the group. The system
automatically creates the
peer in BGP view and
specifies its AS number as
the one of the peer group.
Optional
You can add multiple peers
to the peer group.
Optional
Description
—
Required
By default, the system
does not operate BGP.