Huawei Quidway S5600 Series Operation Manual page 491

Operation Manual – Multicast Protocol
Quidway S5600 Series Ethernet Switches-Release 1510
Table 8-2 Configuration tasks
Configure
information
peers
Configure
application
Configure an MSDP mesh
group
Configure
connection control
8.3.2 Configuring Description Information for MSDP Peers
You can configure description information for each MSDP peer to manage and
memorize the MSDP peers.
Table 8-3 Configure description information for an MSDP peer
Enter system view
Enter MSDP view
Configure
information for an MSDP
peer
8.3.3 Configuring Anycast RP Application
If you configure the same interface (usually Loopback interface) addresses on two RPs
in the same PIM-SM domain, the two RPs will be MSDP peers to each other. To prevent
failure of RPF check on SA messages between MSDP peers, you must configure the
RP address to be carried in the SA messages.
Operation Description
description
for MSDP Required
Anycast RP
Optional
Optional
MSDP peer
Optional
Operation
system-view
msdp
description
peer
description text
Huawei Technologies Proprietary
Related section
Section 8.3.2 Configuring Description
Information for MSDP Peers
Section 8.3.3 Configuring Anycast RP
Application
Section 8.3.4
Mesh Group
Section 8.3.5 Configuring MSDP Peer
Connection Control
Command
peer-address
8-9
Chapter 8 MSDP Configuration
Configuring an MSDP
Description
—
—
Optional
The peer-address
argument is the address
of the peer. You can
configure addresses of
multiple peers for multiple
times.
By default, an MSDP peer
has no description text.