Hwtacacs Configuration - Huawei Quidway S5600 Series Operation Manual

Operation Manual – AAA & RADIUS & HWTACACS & EAD
Quidway S5600 Series Ethernet Switches-Release 1510
Table 1-23 Enable the user re-authentication upon device restart function
Operation
Enter system view
Enter
scheme view
Enable
re-authentication
upon device restart
function

1.5 HWTACACS Configuration

1.5.1 Creating a HWTACAS Scheme
HWTACACS protocol is configured scheme by scheme. Therefore, you must create a
HWTACACS scheme and enter HWTACACS view before you perform other
configuration tasks.
Table 1-24 Create a HWTACACS scheme
Operation
Enter system view
Create a HWTACACS
scheme
HWTACACS view
Caution:
The system supports up to 16 HWTACACS schemes. You can only delete the
schemes that are not being used.
If the Fabic function is enabled on the device, you cannot create any HWTACACS
scheme because they are exclusive to each other.
Command
system-view
RADIUS radius
radius-scheme-name
the user
accounting-on
enable [ send times |
interval interval ]
system-view
hwtacacs
and enter
hwtacacs-scheme-name
Huawei Technologies Proprietary
Chapter 1 AAA & RADIUS & HWTACACS
—
scheme
—
By default,
disabled, and the system can
send at most 15 Accounting-On
packets consecutively at intervals
of three seconds.
Command
scheme
1-34
Configuration
Description
this function is
Description
—
Required
By default, no
HWTACACS scheme
exists.