Huawei Quidway S5600 Series Operation Manual page 113

Operation Manual – VLAN
Quidway S5600 Series Ethernet Switches-Release 1510
2.2 Configuring a Port-Based VLAN
2.2.1 Configuring a Port-Based VLAN
I. Configuration prerequisites
Create a VLAN before configuring a port-based VLAN.
II. Configuration procedure
Table 2-4 Configure a port-based VLAN
Operation
Enter system view
Enter VLAN view
Add Ethernet ports to
the specific VLAN
Caution:
The commands above are effective for access ports only. If you want to add trunk ports
or hybrid ports to a VLAN, you can use the port trunk permit vlan command or the
port hybrid vlan command only in Ethernet port view. For the configuration procedure,
refer to the section "Port Basic Configuration – Operation" in Quidway S5600 Series
Ethernet Switches – Operation Manual.
2.2.2 Protocol-based VLAN Configuration Example
I. Configuration requirements
Create VLAN 2 and VLAN 3 and specify the description string of VLAN 2 as home;
Add GigabitEthernet1/0/1 and GigabitEthernet1/0/2 to VLAN 2 and add
GigabitEthernet1/0/3 and GigabitEthernet1/0/4 to VLAN 3.
Command
system-view
vlan vlan-id
port interface-list
Huawei Technologies Proprietary
2-3
Chapter 2 VLAN Configuration
Description
—
—
Required
By default, all the ports belong
to the default VLAN