Huawei Quidway S5600 Series Operation Manual page 306

Operation Manual – Routing Protocol
Quidway S5600 Series Ethernet Switches-Release 1510
Table 3-6 Configure RIP route summary
Operation
Enter system view
Enter RIP view
Enable
automatic
summary
III. Disabling the receiving of host routes
In some special cases, the router can receive a lot of host routes from the same
segment, and these routes are of little help in route addressing but consume a lot of
network resources. After host route receiving is disabled, a router can refuse any
incoming host routes.
Table 3-7 Disable the receiving of host route
Operation
Enter system view
Enter RIP view
Disable the receiving of
host routes
IV. Configuring RIP to filter or advertise the received routes
The route filtering function provided by a router enables you to configure
inbound/outbound filter policy by specifying an ACL or address prefix list to make RIP
filter incoming/outgoing routes. Besides, you can configure RIP to receive only the RIP
packets from a specific neighbor.
Table 3-8 Configure RIP to filter incoming/outgoing routes
Operation
Enter system view
Enter RIP view
Configure RIP to filter
incoming routes
Command
system-view
rip
RIP-2
route summary
Command
system-view
rip
undo host-route
Command
system-view
rip
filter-policy { acl-number |
ip-prefix
[ gateway ip-prefix-name ] |
route-policy
route-policy-name } import
Huawei Technologies Proprietary
3-7
Chapter 3 RIP Configuration
—
—
Optional
By
automatic
summary is enabled.
Description
—
—
Optional
By default, the router
receives host routes.
—
—
Required
ip-prefix-name
By default, RIP does
not filter any incoming
routes.
Description
default, RIP-2
route
Description