Huawei Quidway S5600 Series Operation Manual page 756

Operation Manual – Mirroring
Quidway S5600 Series Ethernet Switches-Release 1510
III. Configuring RSPAN on the intermediate switch
Table 1-9 Configure RSPAN on the intermediate switch
Operation
Enter system view
Create a remote-probe
VLAN and enter VLAN
view
Define
VLAN
remote-probe VLAN
Exit current view
Enter the view of the
port through which the
intermediate switch is
connected
source
destination switch or
another
switch
Configure the current
port as Trunk
Configure Trunk port to
permit packets from
the
VLAN
IV. Configuring RSPAN on the destination switch
Table 1-10 Configure RSPAN on the destination switch
Operation
Enter system view
Create a remote-probe
VLAN and enter VLAN
view
Define
VLAN
remote-probe VLAN
Exit the current view
system-view
vlan vlan-id
the current
as a remote-probe vlan enable
quit
to the interface
switch,
interface-number
intermediate
port link-type trunk
port
remote-probe remote-probe-vlan-id
system-view
vlan vlan-id
the current
as a remote-probe vlan enable
quit
Huawei Technologies Proprietary
Chapter 1 Mirroring Configuration
Command
interface-type
trunk permit vlan
Command
1-11
Description
—
vlan-id is the ID of the
remote-probe VLAN.
Required
—
—
Required
By default, the port
type is Access.
Required
This configuration is
necessary for ports on
the intermediate switch
that are connected to
the source switch or
the destination switch.
Description
—
vlan-id is the ID of the
remote-probe VLAN.
Required
—