Configuring Trap - Huawei Quidway S5600 Series Operation Manual

Operation Manual – SNMP and RMON
Quidway S5600 Series Ethernet Switches-Release 1510
Add a new user for an SNMP
group
Set the size of SNMP packet
that
send/receive
Set the device engine ID

1.3 Configuring Trap

Trap is the information that the managed device initiatively sends to the NMS without
request. Trap is used to report some urgent and important events (e.g., the managed
device is rebooted).
1.3.1 Configuration Prerequisites
Complete SNMP basic configuration.
1.3.2 Configuration Tasks
Table 1-4 Configure Trap
Operation
Enter system view
Enable the device to
send Trap packets
Enable
the port
to send
Operation
the Agent can
system-view
snmp-agent trap enable [ bgp
[
established ]* |configuration | flash
| ospf [ process-id ] [ ospf-trap-list ] |
standard
coldstart | linkdown | linkup |
warmstart
[ authfailure | newmaster ] ]
Enter port
interface
view or
interface-number
interface view
Huawei Technologies Proprietary
Command
snmp-agent usm-user
v3 user-name
group-name
[ authentication-mode
{ md5 | sha
auth-password
[ privacy-mode des56
priv-password ] ] [ acl
acl-number ]
snmp-agent packet
max-size byte-count
snmp-agent
local-engineid engineid
Command
backwardtransition
[ authentication
]* | system
interface-type
1-6
Chapter 1 SNMP Configuration
Description
} Required
Optional
By default, it is 1,500
bytes.
Optional
By default, the device
engine ID
"Enterprise Number +
device information".
Description
—
|
Optional
By default, the
port is enabled
|
to send Trap
packets.
| vrrp
is