Huawei Quidway S5600 Series Operation Manual page 840

Operation Manual – NTP
Quidway S5600 Series Ethernet Switches-Release 1510
Operation
Associate
specified key with
the corresponding
NTP server
Note:
NTP authentication requires that the authentication keys configured for the server
and the client are the same. Besides, the authentication keys must be trusted keys.
Otherwise, the client cannot be synchronized with the server.
In NTP server mode and NTP peer mode, you need to associate the specified key
with the corresponding NTP server/active peer on the client/passive peer. In these
two modes, multiple servers/active peers may be configured for a client/passive
peer, and a client/passive choose the server/active peer to synchronize to by the
authentication key.
II. Configuring NTP authentication on the server
Table 1-5 Configure NTP authentication on the server
Operation
Enter system view
Enable
authentication
Configure
authentication key
Command
NTP client mode:
ntp-service unicast-server
{ remote-ip | server-name }
authentication-keyid key-id
the
Peer mode:
ntp-service
{ remote-ip | peer-name }
authentication-keyid key-id
Command
system-view
NTP ntp-service authentication
enable
ntp-service
NTP authentication-keyid key-id
authentication-model md5
value
Huawei Technologies Proprietary
1-11
Chapter 1 NTP Configuration
In NTP client mode and
NTP peer mode, you
need to associate the
specified key with the
corresponding
server on the client.
You can associate the
NTP server with the
authentication key while
configuring the switch to
operate in a specific NTP
mode. You can also
unicast-peer
associate
this
configuring
mode where the switch is
to operate
—
Required
By
authentication is disabled
Required
By
authentication
configured
Description
NTP
them using
command after
the NTP
Description
default, NTP
default, NTP
key is not