Huawei Quidway S5600 Series Operation Manual page 316

Operation Manual – Routing Protocol
Quidway S5600 Series Ethernet Switches-Release 1510
one area. A router connecting the backbone area to a non-backbone area is called an
area border router (ABR). An ABR can connect to the backbone area physically or
logically.
Area partition in OSPF reduces the number of LSAs in the network and enhances
OSPF scalability. To further reduce routing table size and the number of LSAs in some
non-backbone areas on the edge of the AS, you can configure these areas as stub
areas.
A stub area cannot import any external route. For this reason the concept NSSA area
(not-so-stubby area) is introduced. In an NSSA area, type 7 LSAs are allowed to be
propagated. A type 7 LSA is generated by an ASBR (autonomous system boundary
router) in a NSSA area. A type 7 LSA reaching an ABR in the NSSA area is transformed
into an AS-external LSA, which is then advertised to other areas.
III. Backbone area and virtual link
Backbone Area
With OSPF area partition, not all areas are equal. One of the areas is different from any
other area. Its area ID is 0 and it is usually called the backbone area.
Virtual link
Since all areas must be connected to the backbone area, the concept virtual link is
introduced to maintain logical connectivity between the backbone area and any other
area physically separated from the backbone area.
IV. Route summary
After an AS is divided into different areas that are interconnected through OSPF ABRs,
The routing information between areas can be reduced through route summary. This
reduces the size of routing tables and improves the calculation speed of routers.
After an ABR in an area calculates the intra-area routes in the area, the ABR
aggregates multiple OSPF routes into one LSA (based on the summary configuration)
and sends the LSA outside the area.
For example, in Figure 4-1, there are three intra-area routes in Area 19: 19.1.1.0/24,
19.1.2.0/24, and 19.1.3.0/24. If route summary is configured, the three routes are
aggregated into one route 19.1.0.0/16, and only one corresponding LSA, which
describes the route after summary, is generated on RTA.
Huawei Technologies Proprietary
4-3
Chapter 4 OSPF Configuration