Huawei Quidway S5600 Series Operation Manual page 429

Operation Manual – Multicast Protocol
Quidway S5600 Series Ethernet Switches-Release 1510
within the multicast VLAN, and also guarantees security because the multicast VLAN is
isolated from user VLANs.
Multicast VLAN is mainly used in Layer 2 switching, but you must make corresponding
configuration on the Layer 3 switch.
Perform the following configuration to configure multicast VLAN.
Table 2-11 Configure multicast VLAN on Layer 3 switch
Enter system view
Create a multicast VLAN
and enter VLAN view
Exit the VLAN view
Create a multicast VLAN
interface and enter VLAN
interface view
Enable IGMP
Exit the VLAN interface
view
Enter the view of the
Ethernet port connected
to the Layer 2 switch
Define the port as a trunk
or hybrid port
Specify the VLANs to be
allowed to pass through
the Ethernet
Table 2-12 Configure multicast VLAN on Layer 2 switch
Enter system view
Enable IGMP Snooping
globally
Enter VLAN view
Operation
system-view
vlan vlan-id
quit
interface Vlan-interface
vlan-id
igmp enable
quit
interface
interface-number
port link-type { trunk |
hybrid }
port
vlan-id-list { tagged |
untagged }
port trunk pvid vlan
vlan-list
Operation
system-view
igmp-snooping enable
vlan vlan-id
Huawei Technologies Proprietary
Chapter 2 IGMP Snooping Configuration
Command
interface-type
hybrid vlan
Command
2-11
Description
—
Create the multicast
VLAN to be configured.
—
—
Required
By default, the IGMP
feature is disabled.
—
—
Required
Required
The multicast VLAN
defined on the Layer 2
switch must be included
and set as tagged.
Description
—
Required
vlan-id is a VLAN ID.