Configuring Rspan Based On Mac Addresses; Establishing The Configuration Task; Configuring Remote Mac Address Mirroring - Huawei Quidway S3700 Series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Device Management

8.9 Configuring RSPAN Based on MAC Addresses

This section describes how to configure RSPAN based on MAC addresses.

8.9.1 Establishing the Configuration Task

Applicable Environment
When incoming packets with the specified source or destination MAC address in a VLAN need
to be monitored on the S3700, you can configure RSPAN based on MAC addresses if the
monitoring interface receiving these incoming packets is not located on the same S3700 as the
observing port.
Pre-configuration Tasks
None.
Data Preparation
To configure RSPAN based on MAC addresses, you need the following data.
No.
1
2
3
4

8.9.2 Configuring Remote MAC Address Mirroring

This section describes how to configure remote MAC address mirroring.
Procedure
l
Issue 01 (2011-07-15)
Data
Type and number of an observing port
MAC address of the packet to be mirrored
ID of the VLAN that the packet with the MAC address to be mirrored belongs to
ID of an RSPAN VLAN
Configure remote MAC address mirroring on the source switch.
NOTE
The mirrored port cannot be added to the RSPAN VLAN.
1. Run:
system-view
The system view is displayed.
2. Run:
vlan vlan-id
An RSPAN VLAN is created and the RSPAN VLAN view is displayed.
3. Run:
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8 Mirroring
90