Huawei Quidway S5600 Series Operation Manual page 217

Operation Manual – MAC Address Table
Quidway S5600 Series Ethernet Switches-Release 1510
MACD MACD
Figure 1-1 A switch uses a MAC address table to forward packets.
After learning the source address of the packet, the switch searches the MAC address
table for the destination MAC address of the received packet:
If it finds a match, it directly forwards the packet.
If it finds no match, it forwards the packet to all ports, except the receiving port,
within the VLAN to which the receiving port belongs. Normally, this is referred to
as broadcasting the packet.
After the packet is broadcast:
If the network device returns a packet to the switch, this indicates the packet has
been sent to the destination device. The MAC address of the device is carried in
the packet. The switch adds the new MAC address to the MAC address table
through address learning. After that, the switch can directly forward other
packets destined for the same network device by using the newly added MAC
address entry.
If the destination device does not respond to the packet, this indicates that the
destination device is unreachable or that the destination device receives the
packet but gives no response. In this case, the switch still cannot learn the MAC
address of the destination device. Therefore, the switch will still broadcast any
other packet with this destination MAC address.
To fully utilize a MAC address table, which has a limited capacity, the switch uses an
aging mechanism for updating the table. That is, the switch removes the MAC
address entries related to a network device if no packet is received from the device
within the aging time. Aging time only applies to dynamic MAC address entries.
MACA MACA
...... ......
Port 1 Port 1
Huawei Technologies Proprietary
MAC Address MAC Address
MACA MACA
MACB MACB
MACC MACC
MACD MACD
Port 2 Port 2
MACD MACD MACA MACA
...... ......
1-2
Chapter 1
MAC Address Table
Management
Port Port
1 1
1 1
2 2
2 2