Huawei Quidway S5600 Series Operation Manual page 282

Operation Manual – MSTP
Quidway S5600 Series Ethernet Switches-Release 1510
1.11 BPDU Tunnel Configuration Example
I. Network requirements
S5600 series switches operate as the access devices of the operator's network,
that is, Switch C and Switch D in the network diagram.
S2000 series switches operate as the access devices of the user's network, that
is, Switch A and Switch B in the network diagram.
Switch C and Switch D connect to each other through the configured trunk port of
the switch, and are enabled with the BPDU Tunnel function. Thereby transparent
transmission is realized between the user's network and the operator's network.
II. Network diagram
Switch C Switch C Switch C Switch C
Switch A Switch A Switch A Switch A
Figure 1-8 Network diagram for BPDU Tunnel configuration
III. Configuration procedure
1) Configure Switch A.
# Enable RSTP.
<Quidway> system-view
[Quidway] stp enable
# Add port GigabitEthernet0/1 to VLAN 10.
[Quidway] vlan 10
[Quidway-Vlan10] port GigabitEthernet 0/1
2) Configure Switch B.
# Enable RSTP.
<Quidway> system-view
[Quidway] stp enable
E 1/0/2 E 1/0/2
E 1/0/1 E 1/0/1
E 0/1 E 0/1 E 0/1 E 0/1
Huawei Technologies Proprietary
E 1/0/1 E 1/0/1
Switch D Switch D Switch D Switch D E 1/0/2 E 1/0/2
E 0/1 E 0/1 E 0/1 E 0/1
Switch B Switch B Switch B Switch B
1-46
Chapter 1 MSTP Configuration