Displaying And Maintaining Multicast Mac Address - Huawei Quidway S5600 Series Operation Manual

Operation Manual – Multicast Protocol
Quidway S5600 Series Ethernet Switches-Release 1510
Create a multicast MAC
address entry.
Note:
If the multicast MAC address entry to be created already exists, the system gives
you a prompt.
S5600 series switches do not support multicast MAC address 0100-5Exx-xxxx.
If a multicast MAC address is added manually, the switch will not learn this multicast
MAC address again through IGMP Snooping. The undo mac-address multicast
command is used to delete the multicast MAC address entries created by the
mac-address multicast command manually, however, it cannot be used to delete
the multicast MAC address entries learned by the switch.
If you want to add a port to a multicast MAC address entry created through the
mac-address multicast command, you must delete this entry first, create this entry
again, and then add the specified port to the forwarding ports of this entry.
The system does not support adding multicast MAC addresses to IRF ports. If a port
is already an IRF port, the system will prompt that you cannot add multicast MAC
addresses to this port.
You cannot enable port aggregation on a port where you have configured a
multicast MAC address; and you cannot configure a multicast MAC address on an
aggregation port.

4.3 Displaying and Maintaining Multicast MAC Address

After the configuration above, you can execute the display command in any view to
verify the configuration effect by checking the displayed information.
Table 4-3 Display and maintain multicast MAC address
Display
MAC
entry/entries
configured
Operation
mac-address multicast
mac-address vlan vlan-id
Operation
display
the multicast
multicast
address
{ { { mac-address vlan
manually
vlan-id | vlan vlan-id }
[ count ] } | count } ]
Huawei Technologies Proprietary
Chapter 4 Multicast MAC Address
Command
Command
mac-address
[ static
4-2
Entry Configuration
Description
Required
The mac-address
argument must be
multicast MAC address
The vlan-id argument is
the ID of the VLAN to
which the port belongs.
Description
You can use the display
command in any view.
a