Huawei Quidway S5600 Series Operation Manual page 821

Operation Manual – SNMP and RMON
Quidway S5600 Series Ethernet Switches-Release 1510
1.6 SNMP Configuration Example
1.6.1 SNMP Configuration Example
I. Network requirements
An NMS and Switch A are connected through the Ethernet. The IP address of the
NMS is 10.10.10.1 and that of the VLAN interface on Switch A is 10.10.10.2.
Perform the following configuration on Switch A: setting the community name and
access authority, administrator ID, contact and switch location, and enabling the
switch to sent trap packet.
II. Network diagram
10.10.10.1 10.10.10.1
NMS NMS
Figure 1-2
III. Network procedure
# Set the community name, group name and user.
<Quidway> system-view
[Quidway] snmp-agent
[Quidway] snmp-agent sys-info version all
[Quidway] snmp-agent community write public
[Quidway] snmp-agent mib-view include internet 1.3.6.1
[Quidway] snmp-agent group v3 managev3group write-view internet
[Quidway] snmp-agent usm-user v3 managev3user managev3group
# Set the VLAN interface 2 as the interface used by NMS. Add port GigabitEthernet
1/0/2 to VLAN 2. This port will be used for network management. Set the IP address of
VLAN interface 2 as 10.10.10.2.
[Quidway] vlan 2
[Quidway-vlan2] port GigabitEthernet
[Quidway-vlan2] quit
[Quidway] interface Vlan-interface 2
[Quidway-Vlan-interface2] ip address 10.10.10.2 255.255.255.0
Ethernet Ethernet
Network diagram for SNMP
Huawei Technologies Proprietary
10.10.10 .2 10.10.10 .2
1/0/2
1-9
Chapter 1 SNMP Configuration