Huawei Quidway S5600 Series Operation Manual page 258

Operation Manual – MSTP
Quidway S5600 Series Ethernet Switches-Release 1510
[Quidway] stp interface GigabitEthernet1/0/1 edged-port enable
Configure in Ethernet port view.
<Quidway> system-view
[Quidway] interface GigabitEthernet1/0/1
[Quidway-GigabitEthernet1/0/1] stp edged-port enable
1.2.13 Point-to-point Link-Related Configuration
A point-to-point link directly connects two switches. If the roles of the two ports at the
two ends of a point-to-point link meet certain criteria, the two ports can transit to the
forwarding state rapidly by exchanging synchronization packets, eliminating the
forwarding delay.
You can specify whether or not the link connected to a port is a point-to-point link in one
of the following two ways.
I. Configuration procedure (in system view)
Table 1-17 Specify whether or not the links connected to the specified ports are
point-to-point links (in system view)
Operation
Enter system view
Specify whether or
not
connected to the
specified ports are
point-to-point links
system-view
the links
stp interface interface-list
point-to-point { force-true |
force-false | auto }
Huawei Technologies Proprietary
Command
1-22
Chapter 1 MSTP Configuration
Description
—
Required
The auto keyword is adopted
by default.
The keyword
force-true
specifies that the
connected to the specified
ports are point-to-point links.
The keyword
force-false
specifies that the
connected to the specified
ports are not point-to-point
links.
The auto keyword specifies
to automatically determine
whether or not the links
connected to the specified
ports are point-to-point links.
links
links