Huawei Quidway S5600 Series Operation Manual page 790

Operation Manual – Cluster
Quidway S5600 Series Ethernet Switches-Release 1510
Note:
Upon the completion of the above configurations, you can execute the cluster
switch-to { member-num | mac-address H-H-H } command on the management
device to switch to member device view to maintain and manage a member device.
You can then execute the cluster switch-to administrator command to resume
the management device view.
You can also reboot a member device by executing the reboot member
{ member-num | mac-address H-H-H } [ eraseflash ] command on the
management device. For detailed information about these configurations, refer to
the preceding description in this chapter.
After the configuration above, on the SNMP host you can receive logs and SMMP
trap messages of all the cluster members.
1.6.2 NM Interface Configuration Example
I. Network requirements
Configure Vlan-interface 2 as the network management interface of the switch;
Configure VLAN 3 as the management VLAN;
The IP address of the FTP server is 192.168.4.3;
The S5600 switch is the management switch;
The S3526E switch and the S2403 switch are the member switches.
Table 1-18 Connection information of the management switch
VLAN (connected
to the switch or
the server)
VLAN 3 (S3526E)
VLAN
Server)
IP address
192.168.5.30/24
2 (FTP
192.168.4.22/24
Huawei Technologies Proprietary
GigabitEthernet 1/0/1
GigabitEthernet 1/0/2
1-19
Chapter 1 Cluster
Connection port