Huawei Quidway S5600 Series Operation Manual page 379

Operation Manual – Routing Protocol
Quidway S5600 Series Ethernet Switches-Release 1510
Configure
advertise community attribute
to each other
Specify routing policy for the
routes exported to the peer
group
Caution:
When configuring BGP community, you must use a routing policy to define the
specific community attribute, and then apply the routing policy when a peer sends
routing information.
For configuration of routing policy, refer to "IP Routing Policy Configuration".
5.7.4 Configuring BGP RR
Table 5-17 Configure BGP RR
Enter system view
Enable BGP, and enter BGP
view
Configure the local router as
the RR and configure the peer
group as the client of the RR
Enable
between clients
Configure cluster ID of an RR
Operation
the peers to
Operation
route reflection
Huawei Technologies Proprietary
Command
peer group-name
advertise-commu
nity
peer group-name
route-policy
route-policy-name
export
Command
system-view
bgp as-number
peer group-name
reflect-client
reflect
between-clients
reflector cluster-id
cluster-id
5-34
Chapter 5 BGP Configuration
Description
Required
By default, no community
attribute or extended
community attribute
advertised to any peer
group.
Required
By default, no routing
policy is specified for the
routes exported to the peer
group.
Description
-
Required
By default, the system
does not operate BGP.
Required
By default, no RR and its
client is configured.
Optional
By default, route reflection
is enabled between clients.
Optional
By default, an RR uses its
own router ID as the cluster
ID.
is