Rip Configuration Example - Huawei Quidway S5600 Series Operation Manual

Operation Manual – Routing Protocol
Quidway S5600 Series Ethernet Switches-Release 1510
Table 3-17 Display and debug RIP configuration
Display the current RIP running
status
information
Display
information
Display RIP routing information
Reset the system configuration
related to RIP

3.7 RIP Configuration Example

I. Network requirements
As shown in Figure 3-1, SwitchC is connected to subnet 117.102.0.0 through an
Ethernet port. SwitchA and SwitchB are connected to networks 155.10.1.0 and
196.38.165.0 respectively through Ethernet ports. SwitchC, SwitchA and SwitchB are
interconnected through Ethernet 110.11.2.0. It is required to configure RIP correctly to
ensure the interworking between the networks connected to SwitchC, SwitchA and
SwitchB.
II. Network diagram
Interface address:
110.11.2.3/24
Switch C
Network address:
117.102.0.0/16
Figure 3-1 RIP configuration
III. Configuration procedure
Operation
and configuration
RIP interface
Interface address:
155.10.1.1/24
Interface address:
Ethernet
110.11.2.1/24
Interface address:
117.102.0.1/16
Huawei Technologies Proprietary
Command
display rip
display rip interface
display rip routing
reset
Network address:
155.10.1.0/24
Switch A
Switch B
Interface address:
Network address:
196.38.165.1/24
196.38.165.0/24
3-13
Chapter 3 RIP Configuration
Description
You can execute the
display command in
any view.
Use this command in
RIP view.
Network address:
110.11.2.2/24