Rip Network Adjustment And Optimization - Huawei Quidway S5600 Series Operation Manual

Operation Manual – Routing Protocol
Quidway S5600 Series Ethernet Switches-Release 1510
Operation
Enable traffic sharing
VII. Configuring RIP to import routes from another protocol
Table 3-11 Configure RIP to import routes from another protocol
Operation
Enter system view
Enter RIP view
Set the default cost for
RIP to import routes
from other protocols
Configure
import
another protocol

3.5 RIP Network Adjustment and Optimization

In some special network environments, some RIP features need to be configured and
RIP network performance needs to be adjusted and optimized. By performing the
configuration mentioned in this section, the following can be implemented:
Changing the convergence speed of RIP network by adjusting RIP timers,
Avoiding routing loop by configuring split horizon,
Traffic sharing based on multiple equivalent routes,
Packet validation in network environments with high security requirements, and
Configuring RIP feature on an interface or link with special requirements.
3.5.1 Configuration Prerequisites
Before adjusting RIP, perform the following tasks:
traffic-share-across-interface
system-view
rip
default cost value
import-route
RIP to
[ process-id
routes from
allow-ibgp
route-policy-name ]*
Huawei Technologies Proprietary
Command
Command
protocol
][ cost value |
| route-policy
3-9
Chapter 3 RIP Configuration
Description
Optional
Description
—
—
Optional
When you use the
import-route
command without
specifying the cost of
imported routes, the
default cost you set
here will be used.
Optional
The allow-ibgp
parameter is used only
for importing BGP
routes.
The process-id
parameter is used only
for importing OSPF
routes.