Huawei Quidway S5600 Series Operation Manual page 521

Operation Manual – 802.1x
Quidway S5600 Series Ethernet Switches-Release 1510
1.5.4 Enabling DHCP-triggered Authentication
After performing the following configuration, 802.1X allows running DHCP on access
users, and triggers authentication when the user dynamically applies IP address.
Table 1-5 Enable DHCP-triggered authentication
Operation
Enter system view
Enable
DHCP-triggered
authentication
1.5.5 Configuring Guest VLAN
Table 1-6 Configure Guest VLAN
Operation
Enter system view
Configure
access method
Enable the Guest
VLAN function
Caution:
The Guest VLAN function is available only when the switch operates in a port-based
authentication mode.
Only one Guest VLAN can be configured for each switch.
1.6 Displaying and Debugging 802.1x
After performing the above configurations, you can display and verify the
802.1x-related configuration by executing the display command in any view.
Command
system-view
dot1x dhcp-launch
Command
system-view
port
dot1x port-method
{ macbased | portbased }
dot1x guest-vlan vlan-id
[ interface interface-list ]
Huawei Technologies Proprietary
1-18
Chapter 1 802.1x Configuration
Description
—
Optional
By default, DHCP-triggered
authentication is disabled.
Description
—
Optional
The default port
method
MAC-address-based. That is,
the macbased keyword is
used by default.
Required
By default, the Guest VLAN
function is disabled.
access
is