Configuration Of Optional Ntp Parameters - Huawei Quidway S5600 Series Operation Manual

Operation Manual – NTP
Quidway S5600 Series Ethernet Switches-Release 1510
Operation
Configure
specified key to be
a trusted key
Enter
interface view
Associate
specified key with
the corresponding
NTP server
Note:
The procedures for configuring NTP authentication on the server are the same as that
on the client. Besides, the client and the server must be configured with the same
authentication key.

1.5 Configuration of Optional NTP Parameters

Optional NTP parameters are:
The local VLAN interface that sends NTP packets
The number of the dynamic sessions that can be established locally
Disabling the VLAN interface configured on a switch from receiving NTP packets
Table 1-6 Configure optional NTP parameters
Operation
Enter system view
Configure the local
interface
sends
packets
Command
the
ntp-service
authentication-keyid key-id
VLAN interface
vlan-id
Broadcast server mode:
ntp-service
broadcast-server
authentication-keyid key-id
a
Multicast server mode:
ntp-service
multicast-server
authentication-keyid key-id
Command
system-view
ntp-service
that source-interface
NTP interface-type
interface-number
Huawei Technologies Proprietary
1-12
Required
reliable
By default, an authentication
key is not a trusted key
vlan-interface
—
In NTP broadcast server
mode and NTP multicast
server mode, you need to
associate the specified key
with
NTP server on the server
You can associate an NTP
server
authentication key while
configuring a switch to
operate in a specific NTP
mode.
associate them using this
command after configuring
the NTP mode where a
switch is to operate
—
Optional
Chapter 1 NTP Configuration
Description
the corresponding
with
You can also
Description
an