Configuring Priority Remark - Huawei Quidway S5600 Series Operation Manual

Operation Manual - QoS&QoS Profile
Quidway S5600 Series Ethernet Switches
Operation
Set the port priority
Table 1-7 Set to use the packet priority
Operation
Enter system view
Enter Ethernet port
view
Set the switch to use
the packet priority
III. Configuration example
Set to use the port priority and specify the priority of GigabitEthernet1/0/1 to 7.
Configuration procedure:
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] interface gigabitEthernet1/0/1
[Quidway-GigabitEthernet1/0/1] undo priority-trust cos
[Quidway-GigabitEthernet1/0/1] priority 7
Set the switch to use the 802.1p priority carried in the packet on
GigabitEthernet1/0/1.
Configuration procedure:
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] interface GigabitEthernet1/0/1
[Quidway-GigabitEthernet1/0/1] priority trust

1.5 Configuring Priority Remark

Refer to 1.1.5 Priority Remark for the introduction to priority remark.
Priority remark can be implemented in the following ways:
Through TP. When configuring TP, you can define the action of remarking the
DSCP priority of the packets out of the traffic limit. Refer to 1.8.2 Configuration
Procedure of TP.
Command
priority priority-level
Command
system-view
interface interface-type
interface-number
priority trust
Huawei Technologies Proprietary
1-13
Chapter 1 QoS Configuration
Description
Optional
By default, the port priority is 0
Description
—
—
Through
configuration, the switch
uses the packet priority
instead of the port priority
this