Troubleshooting Rip Configuration - Huawei Quidway S5600 Series Operation Manual

Operation Manual – Routing Protocol
Quidway S5600 Series Ethernet Switches-Release 1510
Note:
Only the configuration related to RIP is listed below. Before the following configuration,
make sure the Ethernet link layer works normally and the IP addresses of VLAN
interfaces are configured correctly.
1) Configure SwitchA:
# Configure RIP.
< SwitchA >system-view
[SwitchA] rip
[SwitchA-rip] network 110.11.2.0
[SwitchA-rip] network 155.10.1.0
2) Configure SwitchB:
# Configure RIP.
< SwitchB >system-view
[SwitchB] rip
[SwitchB-rip] network 196.38.165.0
[SwitchB-rip] network 110.11.2.0
3) Configure SwitchC:
# Configure RIP.
< SwitchC >system-view
[SwitchC-rip] network 117.102.0.0
[SwitchC-rip] network 110.11.2.0

3.8 Troubleshooting RIP Configuration

Symptom: The layer 3 switch cannot receive any RIP update packet when the physical
connection between the switch and the peer routing device is normal.
Solution: RIP is not enabled on the corresponding interface (for example, the undo rip
work command is executed on the interface) or RIP is not enabled by the network
command on the interface. The peer routing device is configured to work in the
multicast mode (for example, the rip version 2 multicast command is executed) but
the multicast mode is not configured on the corresponding interface of this switch.
Huawei Technologies Proprietary
3-14
Chapter 3 RIP Configuration