Huawei Quidway S5600 Series Operation Manual page 437

Operation Manual – Multicast Protocol
Quidway S5600 Series Ethernet Switches-Release 1510
Operation
Configure
suppression
the
source port
Clear the related
multicast entries
3.2.1 Enable multicast and Configure Limit on the Number of Route Entries
Table 3-2 Enable multicast and configure limit on the number of route entries
Operation
Enter
view
Enable
multicast
Configure
on the number
of multicast
route entries
Note:
To protect the unused sockets against malicious attacks and improve the switch
security, S5600 series Ethernet switches provide the following function:
When the multicast routing function is enabled, the RAW socket used by the
multicast routing function is enabled.
When the multicast routing function is disabled, the RAW socket used by the
multicast routing function is disabled.
This function is implemented in the following scenarios:
Use the multicast routing-enable command to enable the multicast routing
function and enable the RAW socket used by the multicast routing function.
Use the undo multicast routing-enable command to disable the multicast routing
function and disable the RAW socket used by the multicast routing function.
Description
on
Optional
multicast
Optional
Command
system
system-view
multicast routing-enable
limit
multicast route-limit limit
Huawei Technologies Proprietary
Chapter 3 Common Multicast Configuration
Section
Suppression on the Multicast Source
Port
Section 3.2.3
Multicast Entries
—
Required
Multicast must be enabled before
the multicast group management
protocol and the multicast routing
protocol are configured.
Required
By default, the maximum number
of entries in a multicast routing
table is 1024
3-2
Related section
3.2.2 Configure
Clear the Related
Description