Configuring Rspan - Huawei Quidway S3900 Series Operation Manual

Operation Manual – Mirroring
Quidway S3900 Series Ethernet Switches

1.3.3 Configuring RSPAN

I. Configuration prerequisites
The source switch, intermediate switch, and the destination switch have been
determined.
The source port, the reflector port, the destination port, and the remote-probe
VLAN have been determined.
Required configurations are performed to ensure Layer 2
source and destination switches over the
The direction of the packets to be monitored has been determined.
The remote-probe VLAN is enabled.
II. Configuring RSPAN on the source switch
Table 1-9 Configure RSPAN on the source switch
Operation
Enter system view
Create a VLAN and
enter its VLAN view
Define
VLAN
remote-probe VLAN
Exit current view
Enter
Trunk
connected
intermediate switch or
destination switch
Configure Trunk port to
permit packets from
the
VLAN
Exit current view
Configure
source mirroring group
Configure
port
mirroring
system-view
vlan vlan-id
the current
as a remote-probe vlan enable
quit
port view of
ports that
interface
to the
interface-number
port
remote-probe remote-probe-vlan-id
quit
a remote mirroring-group
remote-source
mirroring-group
a source
mirroring-port
for remote
mirroring-port-list
inbound | outbound }
Huawei Technologies Proprietary
Chapter 1 Mirroring Configuration
remote-probe VLAN.
Command
interface-type
trunk permit vlan
group-id
group-id
{ both
1-10
connectivity between the
Description
—
vlan-id is the ID of the
destination
remote-probe VLAN.
Required
—
—
Required
This setting is required
for source switch ports
that connected with the
intermediate switch or
destination switch.
—
Required
Required
|