Dynamic Lacp Aggregation Group - Huawei Quidway S5600 Series Operation Manual

Operation Manual – Link Aggregation
Quidway S5600 Series Ethernet Switches-Release 1510
the system will remain the member ports of the group in LACP-enabled state and
re-aggregate the ports to form one or more dynamic LACP aggregation groups.
II. Port status of static aggregation group
A port in a static aggregation group can be in one of the two states: selected or
unselected. In a static aggregation group, both the selected and the unselected ports
can transceive LACP protocol packets; the selected ports can transceive user service
packets, but the unselected ports cannot.
Note:
In an aggregation group, the selected port with the minimum port number serves as the
master port of the group, and other selected ports serve as member ports of the group.
In a static aggregation group, the system sets the ports to selected or unselected state
by the following rules:
The system sets the "most preferred" ports (that is, the ports take most
precedence over other ports) to selected state, and others to unselected state.
Port precedence descends in the following order: full duplex/high speed, full
duplex/low speed, half duplex/high speed, half duplex/low speed.
The system sets the following ports to unselected state: ports that are not connect
to the same peer device as that of the master port, and ports that are connected to
the same peer device as that of the master port but their peer ports are in
aggregation groups different from the group of the peer port of the master port.
The system sets the ports unable to aggregate with the master port (due to some
hardware limit, for example, cross-board aggregation unavailability) to unselected
state.
The system sets the ports with basic port configuration different from that of the
master port to unselected state.
There is a limit on the number of selected ports in an aggregation group. Therefore, if
the number of the member ports that can be set as selected ports in an aggregation
group exceeds the maximum number supported by the device, the system will choose
the ports with lower port numbers as the selected ports, and set others as unselected
ports.

1.1.6 Dynamic LACP Aggregation Group

I. Introduction to dynamic LACP aggregation group
A dynamic LACP aggregation group is automatically created and removed by the
system. Users cannot add/remove ports to/from it. A port can participate in dynamic link
Huawei Technologies Proprietary
1-4
Chapter 1 Link Aggregation Configuration