Huawei Quidway S5600 Series Operation Manual page 256

Operation Manual – MSTP
Quidway S5600 Series Ethernet Switches-Release 1510
I. Configuration procedure (in system view)
Table 1-13 Configure the maximum transmitting speed for specified ports in system
view
Operation
Enter system view
Configure
maximum
transmitting speed
for specified ports
II. Configuration procedure (in Ethernet port view)
Table 1-14 Configure the maximum transmitting speed in Ethernet port view
Operation
Enter system view
Enter Ethernet port
view
Configure
maximum
transmitting speed
As the maximum transmitting speed parameter determines the number of the
configuration BPDUs transmitted in each Hello time, set it to a proper value to avoid
MSTP from occupying too many network resources. The default is recommended.
III. Configuration example
# Set the maximum transmitting speed of GigabitEthernet1/0/1 port to 15.
Configure the maximum transmitting speed in system view.
<Quidway> system-view
[Quidway] stp interface GigabitEthernet1/0/1 transmit-limit 15
Configure the maximum transmitting speed in Ethernet port view.
<Quidway> system-view
[Quidway] interface GigabitEthernet1/0/1
[Quidway-GigabitEthernet1/0/1] stp transmit-limit 15
1.2.12 Edge Port Configuration
Edge ports are ports that neither directly connects to other switches nor indirectly
connects to other switches through network segments. After a port is configured as an
Command
system-view
the
stp interface interface-list
transmit-limit packetnum
Command
system-view
interface interface-type
interface-number
the
stp transmit-limit
packetnum
Huawei Technologies Proprietary
1-20
Chapter 1 MSTP Configuration
Description
—
Required
The maximum transmitting
speed of all Ethernet ports on
a switch defaults to 10.
Description
—
—
Required
The maximum transmitting
speed of all Ethernet ports on
a switch defaults to 10.