Displaying Igmp - Huawei Quidway S5600 Series Operation Manual

Operation Manual – Multicast Protocol
Quidway S5600 Series Ethernet Switches-Release 1510
The IGMP Proxy feature is disabled by default.
Caution:
Both the multicast routing protocol and the IGMP protocol must be enabled on the
proxy interface.
You must enable the PIM protocol on the interface before configuring the igmp
proxy command. Otherwise, the IGMP Proxy feature does not take effect.
One interface cannot serve as the proxy interface of two or more interfaces.
6.2.6 Removing the Joined IGMP Groups from the Interface
You can remove all the joined IGMP groups on all ports of the router or all the joined
IGMP groups on the specified interfaces, or remove a specified IGMP group address or
group address network segment on the specified interface.
Perform the following configuration in user view.
Table 6-7 Remove the joined IGMP groups from the interface
Operation
Remove the joined IGMP
groups from the interface
Caution:
When an IGMP group is removed from an interface, the IGMP group can join the group
again.

6.3 Displaying IGMP

After completing the aboveonfigurations, you can execute the display command in any
view to verify the configuration by checking the displayed information.
Command
reset igmp group { all |
interface interface-type
interface-number { all |
group-address
[ group-mask ] } }
Huawei Technologies Proprietary
6-13
Chapter 6 IGMP Configuration
Description
Optional