Troubleshooting A Static Route - Huawei Quidway S5600 Series Operation Manual

Operation Manual – Routing Protocol
Quidway S5600 Series Ethernet Switches-Release 1510
[SwitchB] ip route-static 0.0.0.0 0.0.0.0 1.1.4.1
# Configure the default gateway of Host C to 1.1.1.1.
[SwitchC] ip route-static 1.1.1.0 255.255.255.0 1.1.1.1
Now, all the hosts/switches in the figure can interconnect with each other.

2.5 Troubleshooting a Static Route

Symptom: The switch is not configured with a dynamic routing protocol. Both the
physical status and the link layer protocol status of an interface are UP, but IP packets
cannot be normally forwarded on the interface.
Solution: Perform the following procedure.
Use the display ip routing-table
corresponding static route is correctly configured.
Use the display ip routing-table command to view whether the static route is valid.
protocol
Huawei Technologies Proprietary
2-5
Chapter 2 Static Route Configuration
static command to view whether the