Cluster Configuration Example - Huawei Quidway S5600 Series Operation Manual

Operation Manual – Cluster
Quidway S5600 Series Ethernet Switches-Release 1510
Operation
Display state and
statistics
information about a
cluster
Display
information about
the
devices of a cluster
Display
information about
the
members
Clear
statistics on a port

1.6 Cluster Configuration Example

1.6.1 Basic Cluster Configuration Example
I. Network requirements
Three switches form a cluster, in which:
The management device is an S900 series switch.
The rest are member devices.
The S5600 switch manages the rest two member devices as the management device.
The detailed information about the cluster is as follows.
The two member devices are connected to GigabitEthernet1/0/2 and
GigabitEthernet1/0/3 ports of the management device.
The management device is connected to the external network through its
GigabitEthernet1/0/1 port.
GigabitEthernet1/0/1 port of the management device belongs to VLAN2, whose
interface IP address is 163.172.55.1.
All the devices in the cluster use the same FTP server and TFTP server.
The FTP server and TFTP server share one IP address: 63.172.55.1.
The SNMP site and log host share one IP address: 69.172.55.4.
display cluster
the
display cluster candidates
[ mac-address H-H-H |
candidate
verbose ]
the
display cluster members
cluster [ member-num | verbose ]
the NDP reset
[ interface port-list ]
Huawei Technologies Proprietary
Command
ndp statistics
1-15
Chapter 1 Cluster
Description
—