Configuring Port Mirroring - Huawei Quidway S5600 Series Operation Manual

Operation Manual – Mirroring
Quidway S5600 Series Ethernet Switches-Release 1510
[Quidway-acl-basic-2000] rule deny source any
[Quidway-acl-basic-2000] quit
[Quidway] interface gigabitEthernet 1/0/4
[Quidway-GigabitEthernet1/0/4] monitor-port
[Quidway-GigabitEthernet1/0/4] quit
[Quidway] interface gigabitEthernet 1/0/1
[Quidway-GigabitEthernet1/0/1]
monitor-interface

1.3.2 Configuring Port Mirroring

I. Configuration prerequisites
The source port is specified and whether the packets to be mirrored are inbound or
outbound is specified: inbound: only mirrors the packets received via the port;
outbound: only mirrors the packets sent by the port; both: mirrors the packets
received and sent by the port at the same time.
The destination port is specified.
The group number of the mirroring group is specified.
II. Configuring port mirroring in Ethernet port view
Table 1-5 Configure port mirroring in Ethernet port view (1)
Operation
Enter system view
Create a port mirroring
group
Enter Ethernet port view
of the destination port
Define the current port as
the destination port
Exit current view
Enter Ethernet port view
of the source port
Configure the source port
and specify the direction
of the packets to be
mirrored
Display
settings of the mirroring
Command
system-view
mirroring-group
group-id local
interface interface-type
interface-number
monitor-port
quit
interface interface-type
interface-number
mirroring-port
{ inbound | outbound |
both }
display
parameter
mirroring-group { all |
local }
Huawei Technologies Proprietary
1-6
Chapter 1 Mirroring Configuration
mirrored-to inbound
—
Required
—
Required
LACP and TCP must be
disabled on the destination
port.
—
—
Required
Optional
This
executed in any view.
ip-group 2000
Description
command can be