Huawei Quidway S5600 Series Operation Manual page 755

Operation Manual – Mirroring
Quidway S5600 Series Ethernet Switches-Release 1510
Operation
Configure
source mirroring group
Configure
port
mirroring
Configure
reflector port
Configure
remote-probe
for the remote source
mirroring group
Display
configuration
remote
mirroring group
Note:
To mirror tagged packets, you need to configure VLAN VPN on the reflector port.
The reflector port cannot forward traffics as a normal port. Therefore, it is
recommended that you use a idle and in-down-state port as the reflector port, and
be careful to not add other settings on this port.
It is recommended that you do not configure a VLAN as the remote-probe VLAN if
the mac-address max-mac-count 0 command is configured on a port in this VLAN.
Otherwise, remote mirroring may not work properly.
Be sure not to configure a port used to connect the intermediate and destination
switches as the mirroring source port. Otherwise traffic disorder may occur in the
network.
mirroring-group
a remote
group-id
remote-source
mirroring-group
group-id
a source
mirroring-port
for remote
mirroring-port-list
{ both | inbound |
outbound }
mirroring-group
a remote
group-id reflector-port
reflector-port
the mirroring-group
VLAN group-id remote-probe
vlan
remote-probe-vlan-id
the
display
of the
mirroring-group
source
remote-source
Huawei Technologies Proprietary
Chapter 1 Mirroring Configuration
Command
Required
Required
Required
The remote reflector port must
be of the Access type. LACP
and STP must be disabled on
this port.
After a port is configured as a
reflector port, the switch does
not allow you to perform any of
the following configurations:
Required
Optional
This
executed in any view.
1-10
Description
Changing the port type and
its default VLAN ID
Add it to another VLAN
command can be