Troubleshooting Pim - Huawei Quidway S5600 Series Operation Manual

Operation Manual – Multicast Protocol
Quidway S5600 Series Ethernet Switches-Release 1510
[Quidway-pim] c-bsr Vlan-interface 10 30 2
# Configure candidate RPs.
[Quidway] acl number 2000
[Quidway-acl-basic-2000] rule permit source 225.0.0.0 0.255.255.255
[Quidway] pim
[Quidway-pim] c-rp Vlan-interface 10 group-policy 2000
# Configure PIM domain boundary
[Quidway] interface Vlan-interface 12
[Quidway-Vlan-interface12] pim bsr-boundary
When Vlan-interface 12 is configured as the PIM domain boundary, LS_D cannot
receive BSR information from LS_B any mote, that is, LS_D is excluded from the PIM
domain.
3) Configure LS_C
# Enable PIM-SM.
<Quidway> system-view
[Quidway] multicast routing-enable
[Quidway] vlan 10
[Quidway-vlan10] port GigabitEthernet 1/0/2 to GigabitEthernet 1/0/3
[Quidway-vlan10] quit
[Quidway] interface Vlan-interface 10
[Quidway-Vlan-interface10] pim sm
[Quidway-Vlan-interface10] quit
[Quidway] vlan 11
[Quidway-vlan11] port GigabitEthernet 1/0/4 to GigabitEthernet 1/0/5
[Quidway-vlan11] quit
[Quidway] interface Vlan-interface 11
[Quidway-Vlan-interface11] pim sm
[Quidway-Vlan-interface11] quit
[Quidway] vlan 12
[Quidway-vlan12] port GigabitEthernet 1/0/6 to GigabitEthernet 1/0/7
[Quidway-vlan12] quit
[Quidway] interface Vlan-interface 12
[Quidway-Vlan-interface12] pim sm
[Quidway-Vlan-interface12] quit

7.7 Troubleshooting PIM

Symptom 1: The router cannot set up multicast routing tables correctly.
Solution: You can troubleshoot PIM according to the following procedure.
Make sure that the unicast routing is right before troubleshooting PIM.
Huawei Technologies Proprietary
7-23
Chapter 7 PIM Configuration