Huawei Quidway S5600 Series Operation Manual page 909

Operation Manual – FTP and TFTP
Quidway S5600 Series Ethernet Switches-Release 1510
Enter system view
Specify
interface so that the TFTP
client always uses it to
connect
server
Specify the source IP
address so that the TFTP
client always uses it to
connect
server
Display the source IP
address that the TFTP
client always uses it to
connect
server
Note:
The specified interface must be an existing one, and otherwise a prompt appears
to show the configuration fails.
The value of argument ip-address must be an IP address on the device where the
configuration is performed, and otherwise a prompt appears to show the
configuration fails.
The latest connection setting is prior to the fixed setting. That is, if you configure
the source IP address or source interface be used when the TFTP client connect
with an TFTP server for the next time, and the IP address or interface is different
from that set by the source-interface or ftp-server source-ip command, the
former will be used for the next connection.
You may specify only one source interface or source IP address for the TFTP
client at one time. That is, only one of the commands source-interface and
ftp-server source-ip can be effective at one time. If both commands are
configured, the one configured later will overwrite the original one.
1.2.3 TFTP Configuration Example
I. Network requirements
A switch operates as a TFTP client and a PC as the TFTP server.
The TFTP work directory is configured on the TFTP server.
Operation
system-view
the source
tftp
interface-type
with a TFTP interface-number
tftp source-ip ip-address
with a TFTP
display tftp source-ip
with a TFTP
Huawei Technologies Proprietary
Chapter 1 FTP and TFTP Configuration
Command
source-interface
1-16
Description
—
Optional
Optional
This command can be
executed in any view.