Huawei Quidway S5600 Series Operation Manual page 845

Operation Manual – NTP
Quidway S5600 Series Ethernet Switches-Release 1510
Note:
This example assumes that:
Quidway2 is a switch that allows its local clock to be the master clock.
Quidway3 is a switch that allows its local clock to be the master clock and the
stratum of its clock is 1.
II. Network diagram
3.0.1.32/24 3.0.1.32/24 3.0.1.32/24 3.0.1.32/24
Quidway 3 Quidway 3 Quidway 3 Quidway 3
Figure 1-7 Network diagram for NTP peer mode configuration
III. Configuration procedures
1) Configure the S5600 series switch.
# Set Quidway2 to be the time server.
<S5600> system-view
[S5600] ntp-service unicast-server 3.0.1.31
2) Configure Quidway3 (after the S5600 series switch is synchronized to
Quidway2).
# Enter system view.
<Quidway3> system-view
[Quidway3]
# After the local synchronization, set the S5600 series switch to be its peer.
[Quidway3] ntp-service unicast-peer 3.0.1.32
The S5600 series switch and Quidway3 are configured to be peers with regard to
each other. Quidway3 operates in the active peer mode, while the S5600 series
switch operates in the passive peer mode. Because the stratum of the local clock of
Quidway3 is 1, and that of the S5600 switch is 3, the S5600 series switch is
synchronized to Qudiway3.
View the status of the S5600 switch after the synchronization.
[S5600] display ntp-service status
Quidway 2 Quidway 2 Quidway 2 Quidway 2
3.0.1.31/24 3.0.1.31/24 3.0.1.31/24 3.0.1.31/24
3.0.1.33/24 3.0.1.33/24 3.0.1.33/24 3.0.1.33/24
S5600 S5600
Huawei Technologies Proprietary
1-16
Chapter 1 NTP Configuration