Setting The Precedence Of Protocol Packet - Huawei Quidway S5600 Series Operation Manual

Operation Manual - QoS&QoS Profile
Quidway S5600 Series Ethernet Switches
Apply a rule in a Link ACL separately
Apply a rule in an IP ACL and a rule in
a Link ACL at the same time
1.5.3 Configuration Example
GigabitEthernet1/0/1 of the switch is accessed into the 10.1.1.1/24 network
segment
Remark the DSCP precedence of the traffic from the 10.1.1.1/24 network segment
to 56
Configuration procedure:
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] acl number 2000
[Quidway-acl-basic-2000] rule permit source 10.1.1.1 0.0.0.255
[Quidway-acl-basic-2000] rule deny source any
[Quidway-acl-basic-2000] quit
[Quidway] interface GigabitEthernet1/0/1
[Quidway-GigabitEthernet1/0/1] traffic-priority inbound ip-group 2000 dscp 56

1.6 Setting the Precedence of Protocol Packet

The protocol packet carries its own precedence. You can modify the precedence of the
protocol packet through setting its precedence. And then you can match the
precedence with the corresponding QoS action to perform the corresponding QoS
operation on the protocol packet.
1.6.1 Configuration Prerequisites
The protocol type whose precedence needs modification is specified
The precedence value after modification is specified
1.6.2 Configuration Procedure
Table 1-10 Set the precedence of the protocol packet
Operation
Enter
view
ACL combination
Command
system
system-view
Huawei Technologies Proprietary
Form of the acl-rule argument
link-group acl-number rule rule
ip-group acl-number rule rule link-group
acl-number rule rule
—
1-15
Chapter 1 QoS Configuration
Description