Huawei Quidway S5600 Series Operation Manual page 757

Operation Manual – Mirroring
Quidway S5600 Series Ethernet Switches-Release 1510
Operation
Enter the view of the
port through which the
destination switch is
connected
source switch or an
intermediate switch
Configure the current
port as Trunk
Configure Trunk port to
permit packets from
the
VLAN
Exit current view
Configure the remote
destination
group
Configure
destination
remote mirroring
Configure
remote-probe
for
destination
group
Display
configuration
remote
mirroring group
interface
to the interface-number
port link-type trunk
port
remote-probe remote-probe-vlan-id
quit
mirroring-group
mirroring
remote-destination
the
mirroring-group
port for
monitor-port monitor-port
the
VLAN
mirroring-group
the remote remote-probe
mirroring remote-probe-vlan-id
the
of the display
destination remote-destination
Huawei Technologies Proprietary
Chapter 1 Mirroring Configuration
Command
interface-type
trunk permit vlan
group-id
group-id
group-id
vlan
mirroring-group
1-12
Description
—
Required
By default, the port
type is Access.
Required
This configuration is
necessary for ports
through which the
destination switch is
connected to the
source switch or an
intermediate switch.
—
Required
Required
The destination port for
remote mirroring must
be of the Access type.
LACP and STP must
be disabled on this
port.
After you configure a
port as the destination
port for remote
mirroring, the switch
does not allow you to
change the port type or
default VLAN ID of the
port.
Required
Optional
This command can be
executed in any view.