Huawei Quidway S5600 Series Operation Manual page 363

Operation Manual – Routing Protocol
Quidway S5600 Series Ethernet Switches-Release 1510
5.3.3 Configuring Basic BGP Functions
Table 5-4 Configure basic BGP functions
Enter system view
Enable BGP and enter
BGP view
Specify the router ID
Specify the AS number for
the BGP peers
Assign
string for a BGP peer/a
BGP peer group
Activate a specified BGP
peer
Enable BGP logging
Specify
interface for route update
packets
Allow routers that belong
to non-directly connected
networks
EBGP connections.
Operation
system-view
bgp as-number
router-id ip-address
peer
as-number as-number
a description peer { group-name |
ip-address } description
description-text
peer { group-name |
ip-address } enable
log-peer-change
peer { group-name |
ip-address
the source
connect-interface
interface-type
interface-number
peer
ebgp-max-hop
to establish
[ hop-count ]
Huawei Technologies Proprietary
Command
group-name
}
group-name
5-18
Chapter 5 BGP Configuration
Description
—
Required
By default, BGP
disabled.
Optional
This operation is required if
no IP address is configured
for the loopback interface
or other interfaces
By default, a peer is not
assigned an AS number.
Optional
By default, a peer/a peer
group is not assigned a
description string.
Optional
By default, a BGP peer is
active.
Optional
By default, BGP logging is
enabled.
Optional
By default, the source
interface of the optimal
route update packets is
used as the source
interface.
Optional
By default, routers that
belong to two non-directly
connected networks
cannot establish EBGP
connections.
You can configure
maximum hops of EBGP
connection by specifying
the hop-count argument.
is
the